Electronic Flush & Flow Controllers

Valve - Electronic WRAS approved water management system that complies with Bylaw 82 and 83 ABS body PIR sensor 54μA (nominal current), 750mA (peak current for 50ms), 6Vdc (Voltage) Sensor range 3m – 4m Field of view 138º (horizontal), 125º (vertical) Infrared sensor unit may be fitted directly onto solenoid valve assembly, if battery powered, or unit may be mounted remote from the solenoid valve assembly and powered by batteries or from mains supply (solenoid valve supply voltage 6Vac) Two orifice inserts provided to cater for extremes of water pressure - valve unit also provided with built-in flow rate adjuster System activates after detection of someone approaching urinals, allowing regulated flow of water into cistern for approx 30 minutes. Sensor then switches off, saving power After 25 minutes sensor re-actives. If it does not detect anyone within 5 minutes, it closes solenoid valve and waits for next person to enter If during 5 minutes the sensor detects someone else, it leaves solenoid valve open for another 30 minutes Unit incorporates 12 hour hygiene flush cycle, even it if fails to detect anyone during that period 15mm compression connection Note * Pressure reducing valve required either at or approaching the stated maximum pressure. Setting of 2 to 3 bar is recommended Approvals WRC Standards Byelaw 82 and 83